Magnetic/Laser Converter Package

NO Wet Towels ever again

• NO Sticky Electrodes needed
• NO Conductive Gloves necessary Magnets Penetrate Clothing
• Easy Application
• 8 Hour Battery Charge

Portable The NEW Magnetic/Low-Level Laser Converter (MLC) will convert two frequency specific electric current pulses, generated by a Microcurrent Device, into two frequency specific, pulsed magnetic fields. It can also convert the electric current pulses to two frequency specific, pulsed Low-Level Laser light fields. The two frequencies, Frequency A and Frequency B, produced by the Microcurrent device, are sent to the MLC by using the same wires that are currently used to the skin electrodes.

All colors are matched respectively, except for the blue pin jack, it will plug into the black receptacle (port). The two large RJ45 output ports connect the MLC to two Magnetic Discs, two Low-Level Laser Light Discs or one Magnetic Disc and one low-level laser Light Disc. The microcurrent device MUST be set at 100 microamps or greater to produce the magnetic signal.

The MLC unit has a built-in Li-Ion battery pack that will power the system for a minimum of 8 hours from a full charge. The unit may also operate for longer periods by using the power cord attached to the power adapter. The MLC does not have a power switch as it automatically enters an OFF state whenever no microcurrents are being sent to the unit.

When the unit is in the OFF state, with the power cord plugged into the power port, the unit will recharge the internal battery to full charge in about 8 hours or less, depending on the current state of the charge. The power cord supplied with the MLC is the only cord that should be used with the device. Other power cords may cause damage to the MLC.

On the front side of the MLC is a Battery status light. Green indicates a full charge and Red signifies that the unit needs to be charged. Each MLC Magnetic Disc generates seven magnetic fields by means of seven magnetic induction coils.

Four magnetic induction coils generate Frequency A, and three magnetic induction coils generate Frequency B, in the form of a 50% duty cycle square wave. The polarity of a magnetic field is reversed with every pulse. Therefore, polarity of the pulse has no meaning.

Each magnetic induction coil generates a magnetic field of 25 milligauss. Purchase Includes: MLC device 2 blue Magnetic discs Power Cord Laser Discs are optional equipment for an additional charge. NOTE: This product is not intended to diagnose, treat, cure, or prevent any disease.

It is considered a Wellness product.

Just say no to wet towels and electrodes — the Magnetic/LED Converter works with your PDI, Inspirstar or Mend microcurrent unit.